Face milling
Inserts for face mills: many cutting edges per insert (up to 16 on octagonal inserts), high removal rates and an excellent finish on flat surfaces.
Showing all 8 results
ODMT / ODKT
SNGX-GM / SNGX-GE
SEET / SEMT
SZMX
SEKR / SEMR / SEEN
HNMX / HNGX
XNMX / XNGX
SNGX-ZNN / SNMX
Face milling inserts
Face milling uses inserts with a 45° lead angle or double-sided inserts with many edges: SEET and SEMT at 45°, SEKR and SEMR, octagonal ODMT with 16 edges, heptagonal XNMX with 14, hexagonal HNMX with 12 and square SNGX with 8.
The 45° angle thins the chip and allows higher feeds; double-sided inserts reduce the cost per edge in series production on steel and cast iron.
- Deals on inserts, end mills and drills
- New products first
- Technical tips for your shop
Get the offers for October
One email a month with INNOT deals, news and tips for your shop. No spam: unsubscribe with one click.
Check your email
We have sent you a message: click «I confirm my subscription» to receive the offers of the month. If you can't find it, check your spam folder too.
Email already sent
We sent you the confirmation message a few minutes ago: check your inbox and spam folder.
You are already subscribed
This address already receives INNOT offers. See you in the next email!
Subscription confirmed
Thank you! From now on you will receive INNOT offers and news every month.
Subscription cancelled
You will no longer receive the INNOT newsletter. You can subscribe again whenever you like.
Link no longer valid
The link has expired or has already been used. You can subscribe again from this window.
